Linknet I/O Tab; Configuring An Ezns-T100 Network Sensor; Set Up The Temperature Sensor - Delta eZV-440 Application Manual

LINKnet I/O Tab

LINKnet I/O Tab

Configuring an eZNS-T100 Network Sensor

The enteliZONE controller is designed to work with the eZNS network sensor on a LINKnet
network.
This topic describes how to set up the eZNS network sensor's built-in components using the
LINKnet I/O tab on the enteliZONE configuration page.
Configurable controllers can only connect to 1 LINKnet device at a time. This LINKnet
device has to have a device address of "1" in order for it to work with the controller
algorithm. Multiple LINKnet devices (up to 4) are only supported by the programmable
controllers.
On the configuration page, the controller detects the network sensor that is connected to it and
displays only the fields that are relevant for that network sensor.
(enteliWEB only) If you do not have any network sensors online, you can still configure the settings
by selecting your network sensor and model from the Device Information field.
Red Box on LINKnet Tab
(enteliWEB only) When you switch between different network sensor models, active
settings that are not shared between network sensor models become outlined in red. You
need to select the None option to disable these fields.

Set Up the Temperature Sensor

1. In the Sensor Options section, next to Space Temperature sensor type, select the Function
option that is most appropriate for your needs:
Function
None
SpaceTempControl
MonitoringOnly
Page 38 of 84
Select this option if:
The built-in temperature sensor on the eZNS sensor is not used.
The built-in temperature sensor is used to control the space
temperature. An input object (AI1001) is created the sensor
value which will be used by the algorithm to control space
temperature.
Input object AI1001 created but its value will not be used by the
internal algorithm for space temperature control.
eZV-440 Application Guide
Edition 2.6