Assigning Buttons And Slider Elements On Ezns-T100 Network Sensor; Introduction - Delta eZV-440 Application Manual

3. In the Temp Setpoint Type, select the type of setpoint displayed.
Temperature
Setpoint Type
NotDisplayed_
DualSetpoint_
SingleSetpoint_
SetpointOffset_
4. Complete each option to determine how the backlight should appear onscreen.
Backlight
Options
Backlight
Color
Backlight On
Intensity
Backlight Off
Intensity

Assigning Buttons and Slider Elements on eZNS-T100 Network Sensor

Introduction

The enteliZONE controller is designed to work with the eZNS network sensor on a LINKnet
network.
This topic describes how to assign specific functions to every button and slider element on the
eZNS network sensor using the LINKnet I/O tab on the enteliZONE configuration page.
There are as many as 95 button overlay combinations available for the eZNS network sensor.
Fortunately, all these combinations are based on this single layout which consists of 8 buttons and
the slider element:
eZV-440 Application Guide
Edition 2.6
Description
Setpoint will not be displayed.
Separate setpoints are used during heating mode and cooling mode.
The average of both the heating and cooling setpoints.
The offset that you can enter to adjust the occupied heating and
cooling setpoints. The range available for this offset is determined by
the OccSetpointOffsetRange field on the Setpoints tab.
Do the following:
Select a color from the list of available backlight colors.
Enter the desired backlight intensity when the screen is turned on with a
button press. 100% is the most intense.
Enter the desired backlight intensity when the network sensor is idle.
100% is the most intense.
Page 41 of 84