Chapter 7 Application Examples
Click "OK" button to finish the setting. The "Startup Parameters" interface is disaplayed as follows after the
setting is over.
7_
Click
login button and download the EtherCAT configuration data to the AX8 series CPU. Then the
mode of channel 1~ channel 4 of DVP04DA-S is automatically switched to mode 1.
Refer to DVP-PLC Application Manual: Special Modules for details on CR1 in DVP04DA-S.
7.2
Using TwinCAT3 with RTU-ECAT
7.2.1 Configuring the Network via TwinCAT3
Configuring RTU-ECAT
1.
Start the TwinCAT3 software and create a TwinCAT project as below.
7-13