Programming The Ident Profile; Structure Of The Ident Profile - Siemens SIMATIC Ident Function Manual

Configuring the instructions

4.6 Programming the Ident profile

Table 4- 42
Byte
Value
4.6 Programming the Ident profile
4.6.1

Structure of the Ident profile

Note
Parallel operation using Ident instructions and Ident profile is not possible
Note that the CM or reader cannot be operated at the same time using the Ident instructions
and the Ident profile.
The instructions described in the section"Programming add-on instructions (Page 20)"
represent a simplified interface of the Ident profile. If the functionality available with the
instructions is not adequate for your application, you can use the Ident profile as an
alternative. Using the Ident profile, you can set complex command structures and work with
command repetition. The following graphic shows the Ident profile including the commands
that can be implemented with it.
Note
Ident profile for trained users
The Ident profile is a complex instruction containing all the functionality of the Ident
instructions. The Ident profile was developed specially for trained users who want to
configure complex functions with a single instruction. For untrained users, we recommend
using the Ident instructions.
58
Structure of the "PARAM" parameter
1 2...5 6 7...8
0x04 0x00 0x0A 0x00
9 10 11
scan- param option_
ning_ 1
time
Ident profile, Add-on instruction for Rockwell systems
Function Manual, 01/2019, C79000-G8976-C410-03
12 13...14 15
dis- No. of field_
tance_ tran- on_
limiting spond- control
ers
16
field_
on_
time