Siemens SIMATIC Ident Function Manual page 82

Configuring the instructions
4.6 Programming the Ident profile
Byte Value
82
RFID system Meaning
Value of bit 3 ... 0
Value Operating
of bit 3 mode
... 0
0x00 Reserved
0x01 MOBY I
0x05 RF200, RF300
- without multi-
tag mode
0x06 MOBY U - with
mulititag mode
(FB 55)
0x07 RF300 - with
mulititag mode
(FB 55)
Note: Note that after a parameter change the CM must be restarted.
RF600 RFID mode setting
Bit Description
7 ... 5 Presence check and transponder control:
•
•
4 To be assigned the value "0x00".
3 ... 0 RFID mode:
•
•
•
•
Note: Note that after a parameter change the CM must be restarted.
Description
reserved for the setting with the switch or GSD pa-
rameter assignment
If RF300 readers of the 2nd generation are to be oper-
ated in MOBY I mode, the value = 0x01 must be set.
Short "INIT" (only the "param" and "option_1" parame-
ters are transferred to the reader).
ASM 475, ASM 456, RF170C, RF180C
Parameter setting with Multitag > 1 and more than
•
one transponder in the antenna field: the UID pa-
rameter must be supplied with the transponder ID.
Parameter setting with Multitag = 1 and only one
•
transponder in the antenna field: the UID parameter
can be supplied with the correct transponder ID or
zero.
ASM 475, ASM 456, RF170C, RF180C
ASM 475, ASM 456, RF170C, RF180C
0x00 = Operation without presence check
0x01 = Operation with presence check
Antenna is permanently switched on.
0x04 = ISTM mode
0x05 = Single tag mode
0x06 = With single tag mode (UID = 0x00), 4 bytes UID of the 8 byte
handle ID or
With multitag mode, 4-byte UID as handle ID for accessing the tran-
sponder with EPC-ID of any length
0x07 = With single tag mode (UID = 0x00), 8 bytes UID or
With multitag mode, 8-byte UID of bytes 5-12 of 12-byte long EPC-ID
Ident profile, Add-on instruction for Rockwell systems
Function Manual, 01/2019, C79000-G8976-C410-03