Set_Param - Siemens SIMATIC Ident Function Manual
Rfid systems. ident profile, add-on instruction for rockwell systems
Hide thumbs
Also See for SIMATIC Ident:
- System manual (362 pages) ,
- Function manual (142 pages) ,
- Operating manual (80 pages)
Table of Contents
Advertisement
Configuring the instructions
4.5 Programming add-on instructions
4.5.3.7
Set_Param
Using the "Set_Param" instruction, you can change UHF parameters during runtime (e.g. the
antenna power).
Note
Settings saved only temporarily
Note that the parameters in the "Set_Param" instruction are only stored temporarily. If the
power for the reader is interrupted, the stored values are lost and must be set again.
Figure 4-16
Table 4- 19
Parameter
PARMID
VALUE
38
Instruction "Set_Param"
Explanation for the instruction "Set_Param"
Data type
DINT
DINT
Default values
Description
0x00
Parameter identifier
0x00
Parameter value
Ident profile, Add-on instruction for Rockwell systems
Function Manual, 01/2019, C79000-G8976-C410-03
Advertisement
Table of Contents
