Wiring
Figure 4-1:
The analog outputs are on the main board near the hinged end of the enclosure door.
For best EMI/RFI protection, use shielded output signal cable enclosed in earth-grounded
metal conduit.
Keep output signal wiring separate from power wiring. Do not run signal and power or
relay wiring in the same conduit or close together in a cable tray.
4.1.3
Alarm wiring
The alarm relay terminal strip is located just below the power connector on the power
supply board.
See
Figure
14
Analog output connections
4-2.
Rosemount MCL