2.
3.
3.2.4
Electrical connections
Refer to
3.2.5
Installing the sensor
The Rosemount MCL is provided with the sensor cable pre-wired to the transmitter. The
terminal end of the sensor is keyed to ensure proper mating with the cable receptacle.
1.
2.
Instruction Manual
Remove the foam packing insert between the outer tube and the inner overflow
tube.
Adjust the sample flow until the water level is even with the central overflow tube
and excess water is flowing down the tube.
Section 4.1
for details.
Once the key has slid into the mating slot, tighten the connection by turning the
knurled ring clockwise.
Screw the sensor into a plastic fitting, which is held in the flow cell by a union nut.
Do not remove the protective cap on the sensor until ready to put the sensor in
service.
Installation
11