Fingerprint reader module cable
NOTE:
The fingerprint reader module cable is available using spare part number L53428-001.
Before removing the fingerprint reader module cable, follow these steps:
1.
Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn
the computer on, and then shut it down through the operating system.
2.
Disconnect all external devices connected to the computer.
3.
Disconnect the power from the computer by first unplugging the power cord from the AC outlet, and then
unplugging the AC adapter from the computer.
4.
Remove the bottom cover (see
5.
Remove the battery (see
6.
Remove the fingerprint reader module (see
Remove the fingerprint reader module cable:
1.
Release the zero insertion force connector (1) to which fingerprint reader module cable is connected,
and then disconnect the fingerprint reader module cable from the fingerprint reader module.
2.
Remove the fingerprint reader module cable (2).
Reverse this procedure to install the fingerprint reader module cable.
40
Chapter 5 Removal and replacement procedures
Bottom cover on page
Battery on page
29).
Fingerprint reader module on page
28).
38).