Heat Sink - HP ENVY x360 13 Maintenance And Service Manual

Heat sink

Description
Heat sink (includes replacement thermal material)
Before removing the heat sink, follow these steps:
1. Turn off the computer. If you are unsure whether the computer is off or in Hibernation, turn the computer
on, and then shut it down through the operating system.
2. Disconnect the power from the computer by first unplugging the power cord from the AC outlet, and then
unplugging the AC adapter from the computer.
3. Disconnect all external devices from the computer.
4. Remove the bottom cover (see
a. Battery (see
b. Solid-state drive (see
c. Fans (see
d. System board (see
Remove the heat sink:
1. Remove the four Phillips M2.0×3.0 screws (1) that secure the heat sink to the system board.
2. Remove the heat sink (2).
NOTE: The thermal material must be thoroughly cleaned from the surfaces of the heat sink
and the system board components each time the heat sink is removed. Replacement thermal material is
included with the heat sink and system board spare part kits. Thermal paste is used on the processor (1)
and the heat sink section (2) that services it.
Bottom cover on page
Battery on page 29)
Solid-state drive on page
Fan on page 34)
System board on page
28), and then remove the following components:
30)
42)
Component replacement procedures
Spare part number
L53435-001
45