Bottom Cover - HP ENVY x360 13 Maintenance And Service Manual

Bottom cover

Description
In ceramic white finish
In nightfall black finish
Before disassembling the computer, follow these steps:
1. Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn
the computer on, and then shut it down through the operating system.
2. Disconnect all external devices connected to the computer.
3. Disconnect the power from the computer by first unplugging the power cord from the AC outlet, and then
unplugging the AC adapter from the computer.
Remove the bottom cover:
1. Turn the computer upside down with the front toward you.
2. Remove the two rubber foot strips (1).
The rubber foot strips are available in the Rubber Foot Kits, spare part numbers L57883-001 (in ceramic
white finish) and L53439-001 (in nightfall black finish).
3. Remove the following screws that secure the bottom cover to the computer:
(2) Six Phillips M2.5×6.6 screws under the rear rubber foot strip
(3) Two Phillips M2.0×3.3 screws under the front rubber foot strip
(4) Two Torx5 M2.0×4.3 screws on the front edge of the computer
28 Chapter 5 Removal and replacement procedures
Spare part number
L57882-001
L53425-001