Fingerprint Reader Module Cable - HP EliteBook x360 1040 G5 Maintenance And Service Manual

Fingerprint reader module cable

NOTE: The fingerprint reader module cable is included in the Cable Kit, spare part number L41024-001.
Before removing the fingerprint reader module cable, follow these steps:
1. Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn
the computer on, and then shut it down through the operating system.
2. Disconnect all external devices connected to the computer.
3. Disconnect the power from the computer by first unplugging the power cord from the AC outlet, and then
unplugging the AC adapter from the computer.
4. Remove the bottom cover (see
5. Remove the battery (see
Remove the fingerprint reader module cable:
1. Release the zero insertion force (ZIF) connector (1) to which fingerprint reader module cable is connected,
and then disconnect the fingerprint reader module cable from the system board.
2. Release the ZIF connector (2) to which fingerprint reader module cable is connected, and then disconnect
the fingerprint reader module cable from the fingerprint reader module.
3. Detach the fingerprint reader module cable (3) from the keyboard/top cover. (The fingerprint reader
module cable is attached to the system board with adhesive.)
4. Remove the fingerprint reader module cable (4).
Reverse this procedure to install the fingerprint reader module cable.
34 Chapter 5 Removal and replacement procedures
Bottom cover on page
Battery on page 28).
27).