HP ENVY x360 13 Maintenance And Service Manual page 40

4. Remove the bottom cover (see
5. Disconnect the battery cable from the system board (see
Remove the WLAN module:
1. Disconnect the WLAN antenna cables (1) from the WLAN module.
NOTE:
black WLAN antenna cable connects to the WLAN module "#2/Aux" terminal.
2. Remove the Phillips M2.0×2.3 broad head screw (2) that secures the WLAN module to the system board.
The WLAN module rises up.
3. Remove the WLAN module (3) by pulling the module away from the slot at an angle.
Reverse this procedure to install the WLAN module.
32 Chapter 5 Removal and replacement procedures
Bottom cover on page
The #1/white WLAN antenna cable connects to the WLAN module "#1/Main" terminal. The #2/
28).
Battery on page 29).