Selecting Desired Massage Action; Air Controls; Optional Bluewave® Spa Stereo System (J-215 To J-280); Blow-Out Cycle - Jacuzzi J-200 Series Owner's Manual

J-200
10.5

Selecting Desired Massage Action

For models that incorporate a massage selector valve
(Diverter Jet for J-210, Figure A) that allows you to
customize the massage and performance by diverting
water between various jet systems within the spa. Simply
turn valve to positions A, B or C to divert water pressure
to various jet groups.
Note: The valve is intended to operate in positions A
(Combo), B, or C for optimum performance. It is consid-
ered normal for sound levels within the valve to increase be-
tween these positions due to the large amounts of water flowing through
it. For optimum filtration benefits, always leave this valve in position A
when the spa is covered and select positions B or C for maximum jet per-
formance during spa use.
10.6

Air Controls

Certain jet systems have their own air control. Each control
introduces air into the water lines that supply that specific jet group.
Simply turn the air control of choice counterclockwise to open or
clockwise to close.
Note: To minimize heat loss, all air controls should be closed when the
spa is not in use. Certain jets may not draw air when jets pump 1 is
running in low speed; this is considered normal.
10.7 Optional BLUEWAVE® Spa Stereo System (J-215
to J-280)
Spas equipped with the optional Jacuzzi audio system offer
enhanced enjoyment. These models include a high-quality
AUX/Bluetooth stereo receiver with four high-quality marine
speakers for unsurpassed sound quality and long-life.
Note: All operations for the BLUEWAVE system are
controlled via a connected Bluetooth or Auxiliary device.
10.8

Blow-Out Cycle

This cycle will purge the air from the plumbing lines normally caused by
draining and filling the spa. The Jets Pump 1 (low speed) will turn on for
1 minute and then shut off. Then Jets Pump 2 (if equipped) will turn on
and run for 1 minute then shut off. This cycle will only occur at start up.
Note: Turning off the corresponding jets pump that is running can
deactivate the feature.
10.9

Cleanup Cycle

The cleanup cycle occurs once per day at 12:00 PM (noon) for 2
minutes. This is not user programmable. The Jets Pump 1 (low speed)
will turn on for one minute and then shut off. Then Jets Pump 2 (if
equipped) will turn on and run for 1 minute then shut off.
Note: Turning off the corresponding jets pump that is running can
deactivate the feature.
28
A
B C
Figure A