Cleaning Procedure - IBM 9348 Service Information

Cleaning Procedure
Set the Power switch on the
control panel to the Off position.
Note: If you are working on a
table-top unit, go t o step 3.
CAUTION:
When the unit is extended, its
weight can turn over a rack that is
not steady. Before you pull the
unit out of the rack, ensure that a
rack stabilizer is attached to the
bottom front of the rack.
Do not pull out more than one unit
at a time. The rack can turn over
if you pull out more than one unit
at a time.
Pull the release lever located
under the front of the control panel
as shown. Then pull the 9348 out
of the rack until the slide locking
tabs lock.
Chapter
4.
Cleaning
4-3