Table of Contents
Advertisement
Disconnect the signal cable and
the power cable from the rear of
the tape unit.
Note: On the 9348-01 1 and
9348-012, there are three signal
connectors instead of two as
shown. The third connector is not
used.
To prevent damage to the cable
carrier and remove the carrier
bracket do the following:
Remove the cable carrier
hinge screw from the cable
bracket.
Pull the tape unit out the front
of the rack.
Remove the two TORX (T25)
screws and remove the cable
carrier bracket.
Place the tape unit back in the
rack.
Note: If there is no unit above this
one, the tape unit does not need to
be pulled out the front of the rack.
3-1 02
9348
Service Information
Advertisement
Table of Contents
