Slide Stopping Screws - IBM 9348 Service Information

Slide Stopping Screws
CAUTION:
When the unit is extended, its
weight can turn over a rack that is
not steady. B e f o ~ you pull the
unit out of the rack, ensure that a
rack stabilizer is attached to the
bottom front of the rack.
Do not pull out more than one unit
at a time. The rack can turn over
if you pull out more than one unit
at a time.
Press the release lever located
under the front panel as shown.
Then pull the tape unit out of the
rack until the slide locking tabs
lock.
2
Press the locking tabs at the rear
hole on the slides.
Pull the tape unit forward until the
locking tabs lock in the front hole.
RH3B020-1
Chapter 5.
Safety Inspection Guide
5-3