IBM 9348 Service Information page 78

Note: If you are working on a
table-top unit, go to step 4.
CAWION:
When the unit is extended, its
weight can turn over a rack that is
not steady. Before you pull the
unit out of the rack, ensure that a
rack stabilizer is attached to the
bottom front of the rack.
Do not pull out more than one unit
at a time. The rack can turn over
if you pull out more than one unit
at a time.
Pull the release lever located
under the front panel as shown.
Then pull the 9348 out of the rack
until the slide locking tabs lock.
Note: If you are working on a rack
mounted unit, go to step 5.
Press the cover release latch, and
then open the enclosure cover.
Ensure that the tab on the cover
prop goes into the tab slot in the
enclosure.
.
h
Enclosure Cover
3-1 6
9348 Service Information