Remove the three TORX (T25)
screws holding the bottom of the
front panel to the frame. At this
point, the panel remains con-
nected to the frame by many
cables.
Remove the following cables
attached to the front panel:
Display control cable
Door solenoid cable
Door interlock microswitch
cable
Power switch cable
To remove the front panel, pull the
top edge forward first.
Note: Two wires go from the
sensor circuit board to the micre
switches. A third wire (usually a
different color from the other two
wires) is a jumper between the
micmswitches.
Power Switch
Door interlock
icroswitch Cable
3-32
934e
service Information