Table of Contents
Advertisement
Tape
21F7932
I
21F8063
Figure
1-4 (Page 4 of 4). Tape PositioninglServo Reference Codes
The tape unit failed to put the tape in position correctly. This problem
may be caused by a bad tape or a dirty tape path. Clean the tape path;
see "Cleaning Procedure" on page 4-3. Load a tape that is known to
be good and attempt the same read or write operation again.
If this reference code continues to occur, run test 86. If test 86 fails,
exchange the FRUs as needed, and run test 86 after each FRU is
exchanged to verify the repair.
Chapter 1. Analyzing Problems
1-1 7
Action
Probable
Cause
Ref.
Code
Part Number
Advertisement
Table of Contents
