Card And Battery Installation - IBM 9348 Service Information

Card and Battery Installation
If the battery on the buffer card
was removed or if the buffer card
is being exchanged, remove the
battery pmtect tab located
between the battery and the
battery clip.
Then measure the voltage on the
battery. The voltage should be
between 2.5 V and 3.0 V. Do not
use the battery if the voltage is
below 2.5 V.
Note: If the battery was
exchanged, update CONF 15 to
show the year the battery was
exchanged.
/
Battery
3-20
9348
Service Information