Table of Contents
Advertisement
Insert the TORX (T25) screw that
holds the solenoid to the casting.
Hold the solenoid bracket against
the alignment edge on the casting.
Tighten the screw.
Connect the two solenoid power
cables at the clip connection near
the supply motor.
Place the 9348 in the operating
position; see "Placing the 9348 in
the Operating Position" on
page 3-9.
Load a tape to test the hub lock
solenoid.
If the tape loads correctly, the hub
lock solenoid is working.
3-1 00
9348 Service Information
Advertisement
Table of Contents
