Step 9: Test Each Feedback Device - Delta RMC200 Startup Manual

Step 9: Test each Feedback Device

Now that you have connected and tested an actuator, you will verify a
feedback device. The device must already have been wired to the
RMC.
Configure Feedback
In Axis Tools, in the Axis Parameters pane, on the Setup tab, you will
configure certain parameters depending on the type of input you are
using.
Refer to the procedure for your transducer type and module:
Transducer Type
SSI
Start/Stop or PWM (Magnetostrictive)
Quadrature Encoder
Analog (Voltage or Current)
deltamotion.com
Step 9: Test each Feedback Device
Module
S8
S8
Q4, S8, D24
A8
Page
20
20
21
21
19