Step 8: Test Feedback Device - Delta RMC150 Startup Manual

RMC150 Startup Guide

Step 8: Test Feedback Device

Now that you have connected and tested an actuator, you will connect
and verify a feedback device. The device must already have been
wired to the RMC.
Configure Feedback
In Axis Tools, in the Axis Parameters pane, on the Setup tab, you will
configure certain parameters depending on the type of input you are
using.
Refer to the procedure for your transducer type and module:
Transducer Type
Start/Stop or PWM
(Magnetostrictive)
SSI
(linear or rotary)
Analog
(Voltage or Current)
Quadrature Encoder
(A, B, Z)
Resolver
18
Module
MDT (M)
SSI (S),
Universal I/O (UI/O)
ANLG (H), ANALOG INPUTS (A),
ANLG2 (G),
Universal I/O (UI/O)
QUAD (Q),
Universal I/O (UI/O)
RESOLVER (R)
Delta Computer Systems, Inc.
Page
19
19
20
20
20