Ricoh Da-P1 Field Service Manual page 332

3. Appendices: SP Mode Tables
2-212-008 Sheets:JobEnd2
2-212-009 Dist:Interrupt2
2-212-010 Dist:JobEnd2
[LEDA Data:Display]
2221
Displays LEDA data.
2-221-005 Serial No.
2-221-009 Power Error
[T bias Control]
Transfer Bias Control
Use these SP's to adjust the power output and power coefficient used to transfer the
toner image from drum to paper. Four separate voltages are applied before the
leading edge, at the leading edge of the paper, across the image area and at the
2301
trailing edge of the paper.
Notes:
32
• The coefficient adjustment should be done before the power output.
• The amount of voltage applied to each area can be set independently in each
area for the type of paper in use.
[1 to 999 / 3 / 1 / page]
Specifies the cumulative sheet count
threshold from which the previous drum
PCU reverse is performed (Job end).
ENG*
• *Available only when PCU Cold
Mode is ON in LL environment.
[1 to 999 / 6 / 1 / m]
ENG*
• *Available only when PCU Cold
Mode is ON in LL environment.
[1 to 999 / 3 / 1 / m]
Specifies the cumulative running distance
from which the previous drum PCU reverse
(job end) is performed.
ENG*
• *Available only when PCU Cold
Mode is ON in LL environment.
ENG [- / - / -]
ENG [0 or 1 / 0 / 1/step]