Ricoh Da-P1 Field Service Manual page 291

Brightness Sensor Level to Turn On
Set the brightness threshold for the sensor to turn on the main power.
Default: 8
0 (Dark) - 15 (Bright)
Level 0 (Very dark): Equivalent to a moonlit night
Level 5 (Dark): Equivalent to a dimly-lit room
Level 7 (Dim): Equivalent to a room at sunset
Level 9 (Bright): Equivalent to a brightly lit room at night
Level 15 (Very bright): Equivalent to a sunlit room
Fusing Off Mode
Menu > System > Fusg Off Mode(EnSav)On/Off
The user can specify whether the printer enters Fusing Unit Off mode or not.
Default: [Off]
• On
Turn on Fusing Unit Off mode. This setting further reduces power consumption, but the printer may
take longer to recover from Fusing Unit Off mode.
• Off
Turn off Fusing Unit Off mode.
Exit Fusing Unit Off Mode
Specify the condition for the printer to exit Fusing Unit Off mode.
Default: [On Printing]
• On Printing
The printer exits Fusing Unit Off mode when printing is performed.
• On Operating Control Panel
The printer exits Fusing Unit Off mode when any key on the control panel is pressed.
Fusing Unit Off Mode Timer
Specify the period of time the printer waits before entering Fusing Unit Off mode.
The timer is reset if any key on the control panel is pressed or printing is performed.
Default: [10 seconds]
• 10 seconds
• 30 seconds
• 1 minute
Energy Save
289