Subaru Legacy 2003 Service Manual page 440

7) Connect Subaru Select Monitor to data link con-
nector.
(1) Connect Subaru Select Monitor to data link
connector (A) located in the lower portion of the
instrument panel (on the driver's side).
( A )
(2) Connect diagnosis cable to data link con-
nector.
CAUTION:
Do not connect scan tools except for Subaru
Select Monitor and OBD-II general scan tool.
8) Turn ignition switch to ON (engine OFF) and
Subaru Select Monitor switch to ON.
(A) Power switch
9) On the «Main Menu» display screen, select the
{2. Each System Check} and press the [YES] key.
10) On the «System Selection Menu» display
screen, select the {Engine Control System} and
press the [YES] key.
11) Press the [YES] key after displayed the infor-
mation of engine type.
12) On the «Engine Diagnosis» display screen, se-
lect the {Dealer Check Mode Procedure} and press
the [YES] key.
13) When the "Perform Inspection (Dealer Check)
Mode?" is shown on the display screen, press the
[YES] key.
14) Perform subsequent procedures as instructed
on the display screen.
• If trouble still remains in the memory, the corre-
sponding diagnostic trouble code (DTC) appears
on the display screen.
INSPECTION MODE
EN-00710
( A )
EN-00040
EN(H4SO)-43
NOTE:
• For detailed operation procedure, refer to the
SUBARU SELECT MONITOR OPERATION MAN-
UAL.
• For detailed concerning diagnostic trouble
codes, refer to the List of Diagnostic Trouble Code
(DTC).
<Ref. to EN(H4SO)-83, List of Diagnostic Trouble
Code (DTC).>
• Release the parking brake.
• The speed difference between front and rear
wheels may light either the ABS warning light, but
this indicates no malfunctions. When engine con-
trol diagnosis is finished, perform the ABS memory
clearance procedure of self-diagnosis system.
3. OBD-II GENERAL SCAN TOOL
1) After performing diagnostics and clearing the
memory, check for any remaining unresolved trou-
ble data: <Ref. to EN(H4SO)-47, Clear Memory
Mode.>
2) Warm up engine.
3) Connect test mode connector (A) at the lower
side of the instrument panel (on the driver's side),
to the side of the center console box.
( A )
4) Connect the OBD-II general scan tool to its data
link connector (A) in the lower portion of the instru-
ment panel (on the driver's side).
CAUTION:
Do not connect the scan tools except for Suba-
ru Select Monitor and OBD-II general scan tool.
( A )
ENGINE (DIAGNOSTICS)
EN-00711
EN-00710