Siemens SIMATIC Ident System Manual page 71

Required components
For installation with
● 2 antennas (gate)
● 3 antennas (C arrangement)
● 4 antennas (tunnel)
the following components are required:
Table 4- 28
Number for installation
2 ant.
1
2
2
1
1
1
1
Installation information
The cables on the antennas and the antenna splitter are 3.3 m or 10.5 m long. The
write/read device must be installed in the vicinity of the antennas. If there are greater
distances between the write/read device and the antennas, the antenna cable can be
increased by 7.2 m with the extension (6GT2 691-0DH72). This results in shorter ranges.
SIMATIC RF200
System Manual, 09/2013, J31069-D0227-U001-A8-7618
Components required for setting up with 2, 3 or 4 antennas
with
3 ant. 4 ant.
1 1 Basic device:
RF290R (↔ CM or PC)
3 4 Antenna ANT D5 / D6 / D10
3 4 With ANT D6 if required:
cover
2 3 Antenna splitter
1 1 MOBY wide-range power supply unit
for SIMATIC RF systems
(for PC mode only)
1 1 24 V connecting cable, length 5 m
(for PC mode only)
1 1 Connecting cable:
RF290R ↔ PC
or
RF290R ↔ CM
Component
RF200 system planning
4.3 Installation guidelines
Order number
RF290R: 6GT2821-0AC12
optionally:
ASM 475: 6GT2002-0GA10
ASM 456: 6GT2002-0ED00
RF170C: 6GT2002-0HD00
RF180C: 6GT2002-0JD00
RF182C: 6GT2002-0JD10
optionally:
ANT D5: 6GT2698-5AA10
ANT D6: 6GT2698-5AB00
ANT D10: 6GT2698-5AF00
6GT2698-5AD00
6GT2603-0AC00
EU: 6GT2898-0AA00
UK: 6GT2898-0AA10
US: 6GT2898-0AA20
6GT2491-1HH50
6GT2891-4KH ...
optionally:
6GT2891-4F ...
6GT2891-4EH ...
71