Advertisement
20-427 Owner's Manual Draft
3. Push out the top and bottom tabs to hold the sleeve firmly in place.
4. Slide the scanner into the sleeve until it locks in place.
Notes:
• To remove your scanner from the DIN sleeve, insert the two keys straight into the
scanner's front panel. Then, remove the scanner by pulling front panel.
• When mounting in your dashboard, you will need to connect an external antenna and an
external speaker.
mobile mounting in your vehicle
You can mount your scanner under the dashboard, or on top of it, using the mounting
bracket.
1. Attach the three protective rubber feet to the mounting bracket when you use the
scanner on a flat surface. Do not use them when you mount the bracket with screws.
2. Use the supplied mounting bracket as a template to mark positions for the two mounting
screws.
3. At the marked positions, drill holes slightly smaller than the screws.
4. Remove the paper backing from each washer and stick one inside of each bracket's ear,
aligning the washer's hole with the bracket's hole.
5. Attach the mounting bracket to your vehicle's surface using the supplied screws and
lockwashers.
6. Slide the scanner into the bracket, aligning the scanner's holes with the holes in the
bracket, and then screw the mounting knobs into the scanner.
Page 4 of 36
Advertisement
