Advertisement
20-427 Owner's Manual Draft
copying a frequency into an bank 10's empty channel
You can copy a frequency into a vacant channel in a bank 10 (default setting) when the
scanner stops on the frequency during search or tune mode.
1. Press FUNC then ENT when you find a frequency you want to copy. b-10 appears about 2
second, then vacant channel number appears. Press number key to move bank.
2. Press ENT. The scanner stores in the first available vacant channel in the bank. Channel
number and frequency flashes 2 times. All the conditions such as delay condition are copied
on the channel. After about 2 seconds, the scanner automatically returns to search mode.
3. If you try to copy a frequency which is already stored, the scanner sounds the notice tone
3 times after you press ENT. –dUPL– appears on the third line. If you want to copy the
duplicate frequency anyway, press ENT, or if not, press CLEAR to cancel.
copying a frequency into the priority channel
You can copy a frequency into the priority channel (see "Priority") when the scanner stops
on the frequency during Search, Scan, Manual, Tune, or WX mode.
Press FUNC then PRI when the frequency appears. PCH flashes and the frequency (or
000.0000) appears. Press ENT to store the frequency into priority channel, or press CLEAR
to cancel.
band charts
WX (weather) band
Receive mode: FM
1ch
162.400 MHz
2ch
162.425 MHz
Page 14 of 36
Advertisement
