Advertisement
20-427 Owner's Manual Draft
2. Press 0 while WELCOME appears.
3. Press 1. InItIAL appears on the display.
4. Press ENT. WAIt appears for about 2 seconds.
Note: Do not turn off the scanner until the initialization is complete. When the
initialization is complete, 1CH 000.0000 appears on the display.
The FCC wants you to know
This equipment has been tested and found to comply with the limits for a scanning receiver,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This equipment
generates, uses and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television reception, which
can be determined by turning the equipment off and on, the user is encouraged to try to
correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
scanning legally
Your scanner covers frequencies used by many different groups including police and fire
departments, ambulance services, government agencies, private companies, amateur radio
services, military operations, pager services, and wireline (telephone and telegraph) service
Page 34 of 36
Advertisement
