Advertisement
20-427 Owner's Manual Draft
Repeatedly press DIM to adjust the brightness of the display backlight to Dark, Light Off,
or Light.
cloning the programmed data
You can transfer the programmed data to and from another PRO-2054 scanner using an
optional connecting cable with 1/8-inch (3.5mm) phone plugs on both ends (not supplied,
available at your local RadioShack store).
1. Turn on both scanners.
2. Connect the connecting cable to each scanner's PC/IF jack. CLOnE and UP to SEnd
appears.
3. Press /¥ at the host scanner.
4. SEndInG appears at the host scanner.
The scanner sends the data. To exit the clone mode, remove the cable.
CLOnE and Error alternately appears when the scanner receives data from a scanner other
than a PRO-2054. If this happens, turn off the scanner then turn it on again.
care
Keep the scanner dry; if it gets wet, wipe it dry immediately. Use and store the scanner only
in normal temperature environments. Handle the scanner carefully; do not drop it. Keep
the scanner away from dust and dirt, and wipe it with a damp cloth occasionally to keep it
looking new.
replacing the fuse
Page 30 of 36
Advertisement
