Table of Contents
Advertisement
Programming
4. Tap the Weiternähen (Continue Sewing) button.
The program jumps back to the start screen and sewing of the seam
5.9 Continuing a seam after thread breakage
When the machine was set up, the needle thread monitor mode that is
supposed to be active was selected in the machine parameters
(MP 3 ( p. 71)).
In the event of an error, e.g. thread breakage, the machine will undo a
certain number of preset stitches and stop.
The control panel will show the display Fadenriss behandeln
(Manage Thread Breakage):
Fig. 34: Continuing a seam after thread breakage
To continue a seam after thread breakage:
1. Re-thread the needle thread.
2. Use the Vor (Forwards) and Zurück (Back) buttons to move to the
3. Continue sewing.
To cancel sewing after thread breakage and start a new seam:
1. Tap the Abbruch (Cancel) button.
2. Remove the transfer plate.
Operating Instructions 911-210 - 04.0 - 11/2016
continues from the selected point.
point where sewing is to continue.
47
Advertisement
Table of Contents
