Table of Contents
Advertisement
Setup
8.4.1 Setting the working height for stands with rollers
The working height is continuously adjustable between 800 and 1050 mm
(clearance between the floor and upper edge of the tabletop).
Fig. 69: Setting the working height for stands with rollers
①
(1) - Clamping screws
To set the working height for stands with rollers:
1. Support the unit with a lifting carriage or forklift.
2. Loosen all 8 clamping screws (1) on the table legs.
3. Set the tabletop to the desired working height.
Important
Pull out or push in the stand tubes evenly on both sides to prevent jamming.
4. Tighten all 8 clamping screws (1).
5. Remove the lifting carriage or forklift.
104
Operating Instructions 911-210 - 04.0 - 11/2016
Advertisement
Table of Contents
