Table of Contents
Advertisement
Programming
16.8.2 Continuing a seam after thread breaking
When the machine was set up, the needle thread monitor mode that is
supposed to be active was selected in the machine parameters
(MP 3 ( p. 109)).
In the event of an error, the machine will undo a certain number of preset
stitches and stop.
The control panel will show the display Fadenriss behandeln
(Manage Thread Breaking):
Fig. 74: Continuing a seam after thread breaking
Continuing a seam
To continue a seam after thread breaking:
1. Re-thread the needle thread.
2. Use the Vor (Forwards) and Zurück (Back) buttons to move to
3. Continue sewing.
Canceling sewing and starting a new seam
To cancel sewing after thread breaking and start a new seam:
1. Press the Abbruch (Cancel) button.
2. Remove the transfer plate.
3. Press the pedal backwards.
The machine performs a reference run.
4. Press the pedal forwards.
The machine moves to the loading position, and you can start a new
Service Instructions 911-210-10 - 00.0 - 06/2020
the point where sewing is to continue.
seam.
87
Advertisement
Table of Contents
