Kodak DryView 8600 User Manual page 53

DryView 8600 User Guide
Message
REMOVE MISFEED FROM DEVELOPER AREA
(27)
INSERT FILM SAVER TO REMOVE FILM TRAY
REMOVE MISFEED FROM EXPOSURE AREA
(22) INSERT FILM SAVER TO REMOVE FILM
TRAY
REMOVE MISFEED FROM FILM TRAY (20)
INSERT FILM SAVER TO REMOVE FILM TRAY
REPEATED ERROR DURING EXPOSURE (50)
PRESS ENTER TO PRINT ALL QUEUED
IMAGES
TIMEOUT WAITING FOR FILM TRAY REMOVAL
– PRESS ENTER WHEN READY TO REMOVE
TRAY
UNABLE TO FEED FILM (33)
PRESS ENTER TO TRY AGAIN
UNABLE TO UNLOCK FILM TRAY (34)
REMOVE FILM TRAY MANUALLY TO
CONTINUE
UNASSIGNED ERROR CONDITION
VERY FEW STEPS IN TOE OF DLOG E CURVE
VERIFY IMAGE QUALITY
WAIT FOR SHEET TO EXIT BEFORE
REMOVING TRAY FROM IMAGER
WARMING UP
5-6
Operator Action
Film stopped in the developer area.
Check for blockage of film path from
developer. Insert film saver. Raise cover
and open the developer cover. Remove
the film sheet and close the developer
cover. Close the cover and remove the
film saver. Press Enter to continue.
Insert film saver. Raise cover and
remove film from exposure area. Close
cover and remove film saver. Press
Enter to continue.
Insert film saver. Remove film tray.
Remove misfed film sheet.
Press Enter to print all queued images.
Call for service if error persists.
Press Enter. Then remove the film tray
when the release latch is activated.
Message is displayed after third attempt
to feed film. Insert the film saver and
remove the film carrier from the imager.
Gently shake the film carrier. Remove
any film stuck in film tray cavity of
imager and reinsert tray. Press Enter to
try again.
Manually depress the film carrier
release button on the imager and
remove film tray manually.
Call for service.
Examine the quality of the calibration
print. You may have to try new film.
Wait for sheet to exit before removing
tray from imager.
None.
8186546 2000 March Rev. B