Table of Contents
Advertisement
DryView 8600 User Guide
Message
A TO D CONVERTER FAILURE (88)
POWER IMAGER OFF, THEN BACK ON
CALIBRATION FAILED (69)
PRESS ENTER TO LOAD DEFAULT GAMMA
TABLES
CALIBRATION FAIL: Dmin HI, Dmax XXX.X (70)
PRESS ENTER TO BUILD GAMMA TABLES
DEVELOPER OVER TEMPERATURE (17)
POWER IMAGER OFF, THEN BACK ON
DEVELOPER UNDER TEMPERATURE (19)
POWER IMAGER OFF, THEN BACK ON
DOUBLE FILM FEED – REMOVE MISFEED (24)
INSERT FILM SAVER TO REMOVE FILM TRAY
DYNAMIC RAM FAILURE (72)
CALL SERVICE – PRESS ENTER TO CONTINUE
FILM TRAPPED INSIDE EXPOSURE AREA (23)
CALL SERVICE – IMAGER IS INOPERABLE
FILM TRAY EMPTY – INSERT FILM (29)
FILM TRAY UNLOCKED (11).
INSERT FILM TRAY FULLY TO CLEAR ERROR
5-2
Operator Action
Power the imager off, wait 10-20
seconds, then power back on. If
message reappears, call for service.
Press Enter. Then stand by while
imager automatically loads default
tables. Make sure to check image
quality.
Press Enter. Then stand by while
imager automatically builds gamma
tables. If image quality is unacceptable,
use new film.
Unable to control temperature. Power
imager off, wait 10-20 seconds, then
power back on. If message reappears,
call for service.
Unable to control temperature. Power
imager off, wait 10-20 seconds, then
power back on. If message reappears,
call for service.
Insert the film saver and remove the film
tray. Discard any sheets of film that are
jammed in the machine. If problem
persists, call for service.
Power imager off, wait 10-20 seconds,
then power back on. If message
reappears, call for service.
Insert the film saver. Raise the cover
and remove the film from the exposure
area. Close the cover and remove the
film saver. Press Enter to continue. If
film can't be removed, call for service.
Imager is out of film. Remove film tray
and load a new film package.
Remove and reinsert film tray into
Imager.
8186546
2000 March Rev. B
Advertisement
Table of Contents
