Table of Contents
Advertisement
Message
FLASH EPROM FAILURE (75)
CALL SERVICE – PRESS ENTER TO
CONTINUE
GALVANOMETER FAILURE (45)
CALL SERVICE – PRESS ENTER TO
CONTINUE
IMAGE MEMORY FOR INPUT A (B) IS FULL
(80) PRESS ENTER TO CONTINUE
IMAGER OFF-LINE
PRESS ENTER TO PLACE IMAGER IN
SERVICE
IMAGER OPEN (16)
CLOSE COVER
INPUT A (B) ACQUISITION TIMEOUT (66)
INPUT A (B) DMA FAILURE (74)
CALL SERVICE – PRESS ENTER TO
CONTINUE
INPUT A (B) FIFO NOT EMPTY FAILURE (67)
INPUT A (B) HEADER FAILURE (64)
INPUT A (B) IDENTIFY ERROR (63)
CALL SERVICE – PRESS ENTER TO
CONTINUE
INPUT A (B) IMAGE SIZES NOT IDENTICAL
(35) PRESS ENTER TO CONTINUE
INPUT A (B) IMAGE TOO LARGE TO PRINT
(37)
PRESS ENTER TO CONTINUE
INPUT A (B) OVERFLOW FAILURE (65)
2000 March Rev. B
8186546
Section 5 – Troubleshooting
Operator Action
Power imager off, wait 10-20 seconds,
then power back on. If message
reappears, call for service.
Power imager off, wait 10-20 seconds,
then power back on. If message
reappears, call for service.
Press Enter to continue. As films are
printed, memory will become available.
Press Enter to place imager in service.
Be sure the top cover is closed and
latched.
Retry image acquire. Check wire
connections from the modality to the
imager. If problem persists, call for
service.
Power imager off, wait 10-20 seconds,
then power back on. If message
reappears, call for service.
Reacquire the image to be printed.
Try acquiring an image again. If problem
persists, call for service.
Power imager off, wait 10-20 seconds,
then power back on. If message
reappears, call for service.
Verify the image is the same size as the
previously captured image.
Maximum image size is 6.1 megabytes.
Retry with a smaller image.
Try acquiring an image again. If problem
persists, call for service.
5-3
Advertisement
Table of Contents
