Angle Of Rotation (Coordinate Rotation); R Parameters - Siemens SINUMERIK 840C Operator's Manual

5 Parameters
5.3.3

Angle of rotation (coordinate rotation)

Ang le of
rotation
5.3.4

R parameters

...
1 ... n
R param .
chan . spec.
Note
R param .
central
C h a n . s p e c .
A S C II R P
5-14
With this softkey in the Program Parameters area, you select the input menu
for coordinate rotation. Notes on editing can be found in the section "Editing
data in the parameter area". Enter the desired angles of rotation G54 to G57
(angles of rotation G58 and G59 are preset by programming).
R or calculation parameters in a program represent the numerical value of an
address. You can allocate them values within the program and can thus adapt a
program to several similar applications (e.g. different feed, spindle feed,
spindle speed for different materials, working cycles). Parameters consist of the
address R and a maximum four-digit number (except ASCII-R parameters).
Select the desired channel for channel-specific parameters by pressing the
CHANNEL SWITCHOVER key.
You press the R PARAMETER CHANNEL SPECIFIC softkey and the
channel-specific R parameters are called up (R0 ... R699).
The input range is -99999999 to +99999999.
This standard number of 700 R parameters may be modified, see also the
planning note below!
Press the R PARAMETER CENTRAL softkey.
The parameters R700 ... R1299 are displayed.
With the ETC key you can extend the menu bar and
the CHANNEL SPECIFIC ASCII R PARAMETERS softkey is offered.
You can enter any ASCII character in these R parameters. You enter the
program name for the "Select part program for editing" function in plain text
(e.g. MPF1). This function is not activated as a standard; it must be configured
by the machine manufacturer. Please read the machine manufacturer's
documentation.
Editing is described in the section "Editing data in the parameter area".
6FC5198-6AA60-0BP1 © Siemens AG 1999 All Rights Reserved
SINUMERIK 840C, OEM Version for Windows (BA)
01.99