Siemens SINUMERIK 840C Operator's Manual page 205

01.99
Command syntax
Examples
Notes
Start instructions
Command syntax
6-20
Important
Execution from external is not possible due to the necessary name conversion
ZPFn -> SPFn for cycles (zpf files).
With the execution from external, the name of the workpiece in which the file
to be executed is located must be unambiguous within the different workpiece
directories. Different workpieces must not be stored under the same name in
different workpiece directories (e.g. C:\LOCAL and H:\NETWORK\PARTS).
SELECT name CH=nr
name: Part program name (MPF... or SPF...)
CH=nr: Channel number (1 ... 6)
DISK: "Execution from external" is selected "
If "Execution from external" has not been selected, the selected part program
must first have been transferred to the part program memory of the NCK using
a load instruction.
SELECT MPF7 CH = 1 L F
Select part program MPF7 in channel 1:
SELECT MPF7 CH=1
Select part program MPF7 in channel 1 for "Execution from external". After
NC START, part program MPF 7 is loaded section by section from the remote
mass storage device from the workpiece specified in the program pointer.
Important
Execution of the job list of a FlexOS workpiece is only possible if the job list
contains no SELECT instruction.
The SELECT instruction of the job list is only processed if the NCK requests a
workpiece. It is not processed if a workpiece is copied using data management.
The existing job list syntax has been extended with SINUMERIK 840C OEM
Version for Windows so that MMC applications can also be started from the
job list.
Applications which perform e.g. a format conversion can thus be started.
CALL [Drive][Path][Program];[Status]
Drive: Drive on which the application is located
Path: Application path
Program: Program name of the application
Status: WAIT
6FC5198-6AA60-0BP1
[DISK] L F
DISK L F
© Siemens AG 1999 All Rights Reserved
SINUMERIK 840C, OEM Version for Windows (BA)
6 Programming