Siemens SINUMERIK 840C Operator's Manual page 211

01.99
Loading individual files
6-26
Proceed as follows to load an individual file of a workpiece:
• Select the right-hand combo box with the EDIT key.
• Open the combo box with the RIGHT ARROW key and use the vertical
ARROW keys to position the selection bar on "NC Program Memory" or
"NC System Data".
• Press the INPUT key to enter the selected item in the right-hand combo
box.
• Select the left-hand combo box with the EDIT key.
• Open the combo box with the RIGHT ARROW key and use the vertical
ARROW keys to position the selection bar on the workpiece which
contains the desired file.
• Press the INPUT key to enter the selected item in the combo box.
Fig. 6-14 Loading individual files
• Select the list box immediately underneath using the EDIT key.
• Position the selection bar on the desired file. Note the direction of the copy
arrow.
• Press the COPY softkey.
The selected file is loaded into the NCK memory. If a file with the same name
already exists in the NCK memory, a safety prompt appears.
6FC5198-6AA60-0BP1 © Siemens AG 1999 All Rights Reserved
SINUMERIK 840C, OEM Version for Windows (BA)
6 Programming