Cycle Setting Data - Siemens SINUMERIK 840C Operator's Manual

5 Parameters
5.3.6.9

Cycle setting data

C ycle
da ta
5-24
• The cams are combined in pairs. A pair of cams consists of a positive cam
and a negative cam. The area above the positive cam position is assigned to
the positive cam area and the area on the axis below the negative cam
position is assigned to the negative cam area.
• The positive and negative cams combined in a cam pair always refer to one
NC axis.
• After cam positions have been changed, you must first activate a signal
"Transfer of cam values" with an operating sequence (see manufacturer's
documentation) before the changes become effective.
Press the ETC key to extend the SETTING DATA softkey bar.
You select CYCLE SETTING DATA.
The first display for cycle setting data (system data) appears on the screen.
Cycle setting data are separate for each channel. They are grouped into four
system and user areas:
Table 5-1 Overview of cycle setting data
0
. System data
99
400
.
499
800
. System bits
849
900
.
949
Use of the reserved system data is described in the corresponding cycle
descriptions.
6FC5198-6AA60-0BP1
User data
User bits
© Siemens AG 1999 All Rights Reserved
SINUMERIK 840C, OEM Version for Windows (BA)
01.99
Reserved
Free
Reserved
Free