Garmin G1000 Cockpit Reference Manual page 76

Hazard Avoidance
Displaying Weather on the Weather Radar Page
1) Select the Weather Radar Page in the Map Page Group with the FMS Knob.
2) Press the MODE Softkey.
3) If the aircraft is on the ground, select the STANDBY Softkey to initiate the
one minute warm-up period. After the warm-up is complete, the radar will
enter the Standby Mode. After the aircraft is airborne, select the WEATHER
Softkey.
Or:
If the aircraft is already airborne, select the WEATHER Softkey. The one-
minute warm-up period will be initiated, after which the radar will begin
transmitting.
4) Turn the Joystick to select the desired map range.
5) If desired, select the VERTICAL Softkey for vertical scanning.
Adjusting Antenna Tilt
Move the Joystick up or down to adjust the tilt of the antenna up or down.
Monitor the displayed tilt value in the TILT field.
When scanning vertically, a Tilt Line may be displayed to aid in positioning the tilt
of the antenna. If the Tilt Line is not displayed, perform the following steps:
1) Press the MENU Key
2) Turn the large FMS Knob to select 'Show Tilt Line'.
3) Press the ENT Key.
Adjusting Antenna Bearing
Move the Joystick right or left to adjust the azimuth position of the antenna right
or left. Monitor the displayed bearing value in the BEARING field.
When scanning horizontally, a Bearing Line may be displayed to aid in positioning
the antenna for the vertical scan. If the Bearing Line is not displayed, perform the
following steps:
1) Press the MENU Key
2) Turn the large FMS Knob to select 'Show Bearing Line'.
3) Press the ENT Key.
60
Garmin G1000 Cockpit Reference Guide for the Quest KODIAK 100
190-00645-07 Rev. A
™