Garmin G1000 Cockpit Reference Manual page 141

11) Press the Display Database Selection Softkey to show active navigation
database information for each display (MFD1 DB, PFD1 DB, PFD2 DB). Verify
the correct active navigation database cycle information is shown for each
display.
Loading the Jeppesen Navigation Database as the Standby Navigation
Database
The purpose of the Standby Navigation Database is to allow the loading of the
next cycle of the Jeppesen Navigation Database to the bottom SD card, prior to its
effective date. (The Jeppesen Navigation Database is available from Jeppesen seven
days prior to its effective date.)
NOTE: After the navigation database is loaded or copied, the top SD card
may be removed.
1) With the system OFF, insert the SD card containing the new navigation
database version into the top card slot of the MFD.
2) Verify that an SD card is inserted in the bottom slot of each PFD and the
MFD.
3) Turn the system ON. A prompt similar to the following is displayed.
4) Press the YES Softkey. The navigation database is copied to the SD card in
the bottom card slot of the MFD.
5) After the navigation database files are copied to the bottom SD card, the
display will appear as shown in the following figure.
190-00645-07 Rev. A Garmin G1000 Cockpit Reference Guide for the Quest KODIAK
Appendix
125
100
™