Nortel ISDN Signaling Link Description, Installation And Operation page 313

Table 51
File transfer commands (Part 3 of 3)
Command
currLogFilePut hostname,
username, password,
directory path, filename
Example:
prevLogFilePut hostname,
username, password,
directory path, filename
Example:
bootPFilePut hostname,
username, password,
directory path, filename
Example:
hostFilePut hostname,
username, password,
directory path, filename,
ITGFileName
Example:
Table 52
NVRAM IP configuration commands (Part 1 of 2)
Command
NVRIPSet IP address
Example:
ITG Trunk 2.0 ISDN Signaling Link (ISL)
Description
The logFilePut task on the ITG host starts an FTP session with
the given parameters and downloads the ITG card's current log
file to the indicated location on the host.
ITG> currLogFilePut "ngals042", "anonymous", "guest",
"/currDir", "logFile"
The logFilePut task on the ITG host starts an FTP session with
the given parameters and downloads the ITG card's previous
log file to the indicated location on the host.
ITG> prevLogFilePut "ngals042", "anonymous", "guest",
"/currDir", "logFile"
The bootpFilePut task on the ITG host starts an FTP session
with the given parameters and downloads the ITG card's bootp
file to the indicated location on the host.
ITG> bootpFilePut "ngals042", "anonymous", "guest",
"/bootpDir", "bootpFile"
Transfer any file on the ITG card from location ITGFileName
and does a put using FTP to the host indicated by hostname,
username, password, and directory path.
Note: ITGFileName is the full path (that is, path / filename of where the
file is taken from on the ITG card).
ITG> hostFilePut "ngals042", "anonymous", "guest", "/hostDir",
"hostFile", "/C:/CONFIG/CONFIG1.INI"
Description
Set the IP address in NVRAM.
ITG> NVRRIPSet "47.23.34.19"
Maintenance
Description, Installation and Operation
Page 313 of 378