Table of Contents
Advertisement
Change default ESN5 prefix for non-ESN5 IP telephony
gateways
ITG Trunk 2.0 ISDN Signaling Link (ISL)
Install and configure ITG ISL Trunk node
5
Use the command shellPasswordSet to change the default user
name and password for Telnet to ITG shell and FTP to the ITG card file
system. The default user name is itgadmin and the default password
is itgadmin .
You will be prompted for the following information:
Enter current username: itgadmin
Enter current password: itgadmin
Enter new username: newname
Enter new password: newpwd
Enter new password again to confirm: newpwd
6
Record the new user name and password and transmit to authorized
network security personnel.
7
Repeat procedure for all cards in the node.
If the entire sequence of commands is successfully entered, you get the
system response with 'value = 0 = 0x0'. The new user name and password are
now stored in the non-volatile RAM on the ITG card, and will be retained
even if the card is reset, powered-off, or on.
To reset the ITG shell password to its default setting, see "Reset the default
ITG shell password" on page 279.
You must configure an ESN5 prefix for the non-ESN5 IP telephony gateways
by using the "esn5PrefixSet" command from the ITG shell CLI. The default
esn5 prefix (100) corresponds to NCOS 00. If NCOS 00 does not allow access
to all the required trunk facilities, you need to change the default ESN5 prefix
to work with the established NCOS plan in the customer's network. Turn to
"ESN5 network signaling" on page 186. You must perform this procedure on
every card in the node.
1
Select the new ITG Trunk node in the upper part of the IP Telephony
Gateway - ISDN IP Trunk Main window.
2
For each card in the node, right-click on the card and select Telnet to
ITG Card from the right-click menu.
The Telnet window appears with the VxWorks prompt:
Description, Installation and Operation
Page 223 of 378
Advertisement
Table of Contents
