Eaton 9355-F47 Unirom User Manual page 81

Table 9. Menu Map for Display Functions
Main Menu Submenu
UPS Status
Event Log
Measurements
Output
Battery
Input
Bypass
Control
Go to Bypass Mode
Start Battery Test
Display Test
Settings User Settings
Service Settings
Identification
Turn UPS ON/OFF ON and OFF Options
Eaton 9355-F47 Unirom UPS (10/15 kVA) User's Guide
The following table shows the basic menu structure.
Display Information or Menu Function
UPS off / System normal / UPS supporting load / UPS on battery / UPS on
bypass / Active alarm list / Battery status
Displays up to 100 events and alarms
L-N and L-L / Current / Frequency / Power
Voltage / Current / Runtime
L-N and L-L / Current / Frequency
L-N and L-L / Frequency
Transfers the UPS to internal Bypass mode
When this command is active, the option changes to Go to Normal Mode.
Initiates a battery test
Four different selectable tests for the front panel functions: the LEDs cycle
through, the alarm beep sounds, the backlight turns off and on, and the
pixels scroll through to test the LCD.
See Table 10 for detail.
This screen is password-protected.
UPS Type / Part Number / Serial Number / Firmware / Display / CAN Bridge
NOTE The CAN Bridge option is not used.
S
164201642 Rev C www.eaton.com/powerquality
OPERATION
75