Eaton 9355-F47 Unirom User Manual page 25

7. Remove the four M4 screws securing the rear stabilizing bracket to
NOTE Be sure to retain the rear stabilizing bracket and hardware for later re-assembly onto
the UPS.
NOTE Hold the UPS so that the bolts can be removed easily without the UPS rolling
backward.
8. Remove the two M10 bolts securing the front shipping bracket to
Eaton 9355-F47 Unirom UPS (10/15 kVA) User's Guide
the cabinet rear panel and remove the bracket (see Figure 6). Retain
the hardware for later use.
the pallet. Remove the four M4 screws securing the bracket to the
cabinet front panel and remove the bracket. See Figure 6.
M4 Screws
(under CB box)
Figure 6. Removing the Brackets
S
164201642 Rev C www.eaton.com/powerquality
UPS SETUP
M10 Bolts
M4 Screws
Front
Shipping
Bracket
Rear Stabilizing Bracket
19