Error Message List - Sony RM-280 Operation Manual

Error Message List

Message
Upper Lower
portion portion
VTR CTRL VTR CTRL
LRN ERR LRN ERR
REC INHI (none)
EDIT ERR E PRESET
EDIT ERR ED POINT
SRCH ERR SRCH ERR
SV UNLCK SV UNLCK
SYNC ERR SYNC ERR
VTR TYPE VTR TYPE
REF MISS (none)
HARD ERR KY COMM
HARD ERR NVRAM ER NVRAM read/write error
HARD ERR FPGA
Meaning
This unit can't control VTRs after automatic
control operation including the LEARN function
begins.
The VTR is in the standby mode when
automatic control operation including the
LEARN function begins.
The recorder is in rec-inhibit mode.
You haven't set the edit mode before starting the
automatic editing.
The setting for edit is not appropriate before an
automatic edit.
Search function with the GOTO button can't be
performed.
The tape doesn't have enough leeway for
preroll.
The servo-mechanism of the VTR is not locked
at the IN point (when the setup menu item 08
SVLCK ER is set to ABORT).
Synchronization between the player and the
recorder can't be performed (when the setup
menu item 05 SYNC SEL is set to other than
OFF).
The type of the VTR can't be detected during
the automatic editing.
The reference signal is not input to the recorder. Input the reference signal to the recorder.
KY communication error
FPGA error
Action
Make sure that the VTR 9PIN REMOTE is set to
ON.
Make sure that a cassette (or a recording
media) is inserted.
Perform the start delay LEARN function for both
VTRs simultaneously.
Check the REC/SAVE switch of the cassette
and the status of the REC INHI setting of the
recorder, and cancel the rec-inhibit mode.
Make sure that you select the edit mode with
some of the ASSEMBLE, VIDEO, and the A1 to
A4 buttons lit.
Note
Edit mode isn't set if any of the ASSEMBLE,
VIDEO, or A1 to A4 buttons flash.
Make sure that the duration is not zero, or that
the OUT point is not set before the IN point.
Make sure that the timecode to cue up for exists.
Make sure that the material tape or the
recording tape is recorded correctly.
Check the preroll time setting on the setup
menu item 01. If the preroll time is shorter than
the minimum preroll time of the VTR, set the
preroll time to a longer amount.
Determine the start delay setting with the
LEARN button and set the setup menu item 10
and 11 to LEARN.
Set the timing of the editing manually.
Contact your Sony service representatives.
Contact your Sony service representatives.
Contact your Sony service representatives.
81
Error Messages