Table of Contents
Advertisement
Q00
|S
oO Boma
oocm
(ERROR |
Error indication
Message
Error Messages in the Display Window
|
Cj
Error number (flashing)
Countermeasure
The OUT point comes before the IN point of the Cut.
Locate the unnecessary IN or OUT point using
<=PGM/PGM=>,
and press C. Designate again.
The iN or OUT point of the previously programed Cut
is designated again.
The previous program remains in the RM-E700. The
counter (hour/minute/second, 4-digit, RC time code)
of the previous player was different from that of the
present player.
You pressed PGM when the player is neither
connected nor turned on.
The player is disconnected while you are
programming, or while you are sending the tape from
the IN point to the OUT using GO TO.
If you want to change the IN or OUT point of the Cut,
see page 27. To program another Cut, locate the
desired IN or OUT point using <=PGM/GPMc=>
buttons.
Press AC to clear all the Cuts, then enter a new
program. When the player has a counter selector, set
to the same counter.
Connect the player to the RM-E700 or turn on the
player. "
Connect the player and the RM-E700, or turn on the
player.
When beginning the program editing, the counter
({hour/minute/second, 4-digit, RC time code) of the
program is different from that of the present player.
Press AC to cancel all the Cut, then enter the
program again. When the player has a counter
selector, set to the same counter before program
editing.
During the program editing, the necessary function of
the remote control unit was not stored, when the
recorder is not Sony's.
Store the function of the remote commander, see
page 18. It is necessary to store the recording,
playback, stop, fast-forward, rewind and pause
functions.
During the program editing or scene-by-scene editing,
the safety tab of the tape in the recorder is set to
prevent recording.
Check if you may record on the tape, then set the
safety tab for recording.
When the player is not connected, or is not turned
on, you pressed either PGM EDIT, VIDEO EDIT, or
PREVIEW button.
Connect the player and the RM-E700, or turn on the
player. "
Message
Countermeasure
During program editing, previewing, or scene-by-
scene editing, the player is disconnected, or is turned
off.
Connect the player and the RM-E700, or turn on the
player. "
Appears when you try to store the video image title in
PAGE 3 or 4 with the IMAGE 2/4 selector set to 2.
When
the IMAGE 2/4 selector is set to 2, you cannot
store the video image title in PAGE 3 or 4. To store
the video image title in PAGE 3 or 4, set the IMAGE
2/4 selector to 4.
During editing by the RC time code, appears when a
Cut is as long as 4 to 29 frames (4/30 to 29/30
seconds) for the NTSC system models, and 4 to 24
frames (4/25 to 24/25 seconds) for the PAL models.
1) With some player models, the error message does not
appear when the player is turned off.
2) With some player or recorder models, the program
editing is inoperative even if the error message does not
appear, when the Cutis more than 1 second long. After
programming, check that the program editing is
operative.
With some player or recorder models, you may not be
able to edit as desired. After programming, check that
the program editing is operative. ?
53
Advertisement
Table of Contents
